Installation variant D
Step 2 from 3
Glue helmet adapter
Place the helmet adapter (1) in the forehead area of the helmet between the inner shell and the outer shell (red marking). The mark on the bottom of the helmet adapter (2) should be on an imaginary line between the center of the helmet and the center of your face (dashed line). Make sure that the helmet adapter does not collide with the sun visor. Press the helmet adapter firmly and evenly onto the mounting surface so that Sugru adheres to the helmet with its full surface area.
Check helmet adapter
Check whether the helmet adapter is correctly attached to the helmet. To do this, attach the head-up display to the helmet adapter using the magnets. The head-up display must be fully attached to the helmet adapter without a visible gap in between.
Make sure that the helmet adapter does not collide with the sun visor. Then press the helmet adapter evenly onto the helmet.
If the mounting surface is curved and the helmet adapter does not fit correctly against the mounting surface, apply an additional layer of Sugru to compensate for the unevenness.